350-001 Questions And Answers

QUESTION 1
Which two commands are required to enable multicast on a router, knowing that the receivers only support IGMPv2? (Choose two.)

A. ip pim rp-address
B. ip pim ssm
C. ip pim sparse-mode
D. ip pim passive

Answer: AC


QUESTION 2
A branch router is configured with an egress QoS policy that was designed for a total number of 10 concurrent VOIP calls.

Due to expansion, 15 VOIP calls are now running over the link, but after the 14th call was established, all calls were affected and the voice quality was dramatically degraded.

Assuming that there is enough bandwidth on the link for all of this traffic, which part of the QoS configuration should be updated due to the new traffic profile?

A. Increase the shaping rate for the priority queue.
B. Remove the policer applied on the priority queue.
C. Remove the shaper applied on the priority queue.
D. Increase the policing rate for the priority queue.

Answer: D


QUESTION 3
A new backup connection is being deployed on a remote site router. The stability of the connection has been a concern. In order to provide more information to EIGRP regarding this interface, you wish to incorporate the "reliability" cost metric in the EIGRP calculation with the command metric weights 1 0 1 0 1.

What impact will this modification on the remote site router have for other existing EIGRP neighborships from the same EIGRP domain?

A. Existing neighbors will immediately begin using the new metric.
B. Existing neighbors will use the new metric after clearing the EIGRP neighbors.
C. Existing neighbors will resync, maintaining the neighbor relationship.
D. All existing neighbor relationships will go down.

Answer: D